Penis Enlargement Products and Forum

[gmr19]

Hello,

I purchased the Starter kit thinking it would be the right size for me. I am 4.0" Flaccid Length (measuring from base of penis to tip, not pushing on stomach) and 6.5" Stretched Flaccid Length which is also my regular Erect Length. So I should not need the mini, correct?

The way the X4 comes in the mail it is too small for me as the screws completely come out of the base before the X4 compresses at all (no tension on penis). So I added the 2" rods and that is too long I think. With the 2" rods added, I'm able to stretch my flaccid penis about an inch beyond the white support piece. However, I cannot strap in while stretching. I don't think you're supposed to anyway. I also cannot strap in when pushing the support piece towards my body since it's too long.

Do I HAVE to buy the $140 Quad Upgrade Kit JUST to get the elongation rods? I can't buy these rods separate??

Thanks all!

[lilfrig]

you can buy just the rods in the spare parts/accessories. The proper way to strap in is.....compress your extender against your body; pull your flaccid penis through the strap with the foam pad already on your penis just below your head. You should have just enough rods on to get the head just passed the strap while compressed. Then the foam pad lines up. Once through and lined up, strap down then slowly release tension. Once in this position you should feel some stretch and may need to adjust the screws accordingly for more tension as required. Hope this helps.

[gmr19]

I am following your strap-in procedure. Without adding rods, my penis still stretches beyond the extender AND after I extend it out completely via the thumb screws. Then the screws fall out of the base. All this while seeing zero compression of the extender.

When I add the 2" extension rods, then it's too long. I can BARELY get my head strapped in, which is not the proper method. I don't want it pulling on my head. It's like I need some 1" extension rods.

[Newby101]

take off the smaller rods then add the 2" rods, then try again if to small try adding your next smallest rod onto the 2" rod and see how it goes. Im not sure what all comes with the starter as I bought the deluxe version because it comes with more rods.

--101

[gmr19]

I can't take off the smaller rods as they are part of the spring loaded assembly. The starter kit comes only with one set of 2" rods. I guess I have to buy some small rods.

[Dangler]

cut either a dowel, or wooden pencil to about (guessing) half inch, 2 ea. Insert these into the mounting head, then put the metal rods in. That ought to help until parts are ordered & arrive.